Over-Molded Conduit End Fittings for Push Pull Cables
Over-Molded Handles for Pull Controls, Wire Rope Assemblies
Vertical Shuttle Molding:
Overmolding components used for mechanical pull controls is a cost effective option for larger volumes when compared to a crimped metal fitting. This is due to the over molded component being created and attached in one operation using a multi-cavity tool with secondary finishing not being required.
Shuttle molding capabilities for pull control mounting flag brackets, body tubes, and threaded ends molded over conduit.
Pull handles and knobs can be over-molded over metal rods, tubes, or directly over cable.
Capabilities for overmolded connectors for wire harnesses used on electronics applications.
Injection Molded Gears, Knobs, Caps, Connectors, etc.
Horizontal Injection Molding:
Panel components including gears, knobs, and face-plates.
Variety of products including electrical connectors, caps, and industrial spools.
Experience with wide range of materials including: ABS, acetal, acrylic, nylon, polypropylene, PVC, PBT, and thermoplastic elastomers (TPE).
Zinc Diecast Cable Ends for Wire Rope Assemblies
Cable end fittings including ball, barrel, clevis, and eye ends.
Cable fittings are overmolded over cable using ZAMAK 3 zinc diecast alloy.
Coiled cable available for support applications including hood support/assist cables for heavy truck.
Contact us to discuss your specific push pull cable, wire rope assembly and electronic assembly requirements: